The fully automatic creep tester with 10 measuring points is used to investigate the creep behavior of adhesives and plastics as well as smaller joints. The load of up to 10,000 N per sample is applied via a lever system and static weights. Counterweight sets also allow extremely low loads of a minimum of 2 N. The strain measurement is carried out without contact with a mobile CCD camera. The test chamber can be tempered in a range of -20 °C to 150 °C. The system is equipped with a pneumatic loading system so that the load on the samples with the weights is always uniform. The introduction of additional energy into the sample is thereby avoided, which is decisive in particular for the quality of the measuring results, particularly in the case of ductile material. Shock absorbers prevent impingement on neighboring test points in case of failure of a sample.